Canems ECU (part 1..)

I decided to have a look at the Cannes ECU and see how much I can fit prior to the body going on. Most was self explanatory however I did get a bit stuck with the Cam sensor (AG on diagram below), but after a quick chat with Jon at AK it was all resolved. There is a cam sensor extension (see below) on the LS3 engine which needs to be taken off prior to fitting the Cam sensor. It's slightly tight to get a spanner so if you are reading this and you haven't yet installed your engine I would suggest taking this off in advance! There are also 2 sensors (J & K on diagram below) that are not used.

I now need to tidy up the cabling a little and cable tie where necessary, tighten the 2 x ring terminals to earth points (V on diagram below), tighten the 2 x terminals to permanent 12v supply (H on diagram below), and glue in the Intake air temperature sensor (AD on diagram below). I will be tackling the ECU connectors and other fittings once the body is on. 

The above Cam sensor extension bracket (I'm not sure of the exact name but that's what i'm calling it!) needs to be removed before connecting the Cam position sensor