Savage Switches, Dash Lights & Ignition Barrel Wiring Info - Plus car off to Intatrim

So I've spent the last few weeks on the wiring and more recently it's been the Savage switches, Dash lights and Ignition barrel that I have been working on. I've been documenting what wires go where and below are some very basic drawing outline what I've done. The only change to the below is the Blue wire running to the Battery Charge Warning Light. Originally I used the Blue wire from the AK Loom, which didn''t work. I then realised, whilst transporting my Cobra up to Intatrim there is a Blue wire from the Canems loom that needs to go here instead! When we arrived I set about swapping the cables over. It was with a bundle of cables I had marked 'not required' and it was easy to locate the correct wire. I removed the blue cable from the Eight Pin Plug connected to the AK loom, added a spade connector to the blue canems wire, then slotted it in place. I didn't have the opportunity to test that it was working so I will need to test this when it comes back...

Blue Cable for Battery Charge Warning Light replaced with Blue cable from Canems loom (replaced within the eight pin plug to keep it neat)

The bottom drawing (side lights) on the above should show 'black/white daisy chained for illumination, same as main beam...

The electric handbrake diagram above shows red going to switched live, I changed this so it went to illumination instead and used brown coloured wire!!!

It was right to the wire getting my Cobra ready for its trip to Intatrim but finally made it with not much time to spare. We had a 13 hour round trip to Intatrim in Telford and we were definitely ready for a break, luckily we were going away on a two week cruise the very next day!

Now looking forward to it's return with the interior trim completed....