Alan's and Dad's Cobras back from Intatrim, plus a few bits requiring attention following my Interior trim....

So it's the beginning of December and we now have all 3 Cobras back from the trimmers (Intatrim). All in all pleased with how they have turned out.

Unfortunately there was a few minor issues with mine following the trim being completed by Intatrim... The first requiring my attention was the dash wiring as a number of cables were hanging loose. I took the dash back out and set about reconnecting the loose wires, I am glad I made a note of all the wiring as this made it not too much of a task! The next job was to cut a hole in the carpet and fit the heater inlet as unfortunately this had been left out and carpeted over. The reset/function setup switch for the speedo was also not fed through and was left loose behind the dash. It's a very tight fit for this now the trim is on but it's now done, minus the black cap, which unfortunately went missing during the trimming. I am sure I can find a replacement.  

I will be testing all connections and will aim to tidy this birds nest up a bit before putting the dash back in!